B. C.F.F. Motor1) Disconnect the connector of the C.F.F. con-troller PCB.2) Remove the rear cover.3) Mark the position of the connector mount qwith a scribe, and remove the screws w e;then, loosen the screw r.Figure 4-12054) Slide the connector mount as indicated; then,using a hex wrench t, remove the clock platey.Figure 4-12065) Remove the drive belt u.Figure 4-12076) Remove the mounting screw i, and removethe C.F.F. motor o.Figure 4-12087) To assemble, tighten the screw i temporarily;then, tighten it fully after making sure that thetensioner !0 is in contact with the belt and ispushing to apply a specific tension.4. MECHANICAL SYSTEMCOPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON) 4-101123 456788 88910
