182Although using the self-timer or a remote switch can prevent camerashake, using mirror lockup to prevent camera vibrations (mirror shock)can also help when you use a super telephoto lens or shoot close ups(macro photography).1 Set [Mirror lockup] to [Enable].Under the [z2] tab, select [Mirror lockup], then press <0>.Select [Enable], then press <0>.2 Focus the subject, then press the shutter buttoncompletely.XThe mirror will swing up.3 Press the shutter button completely again.XThe picture is taken and the mirror goes back down.2 Mirror LockupNIn very bright light, such as at the beach or a ski slope on a sunny day,take the picture promptly after mirror lockup.Do not point the camera toward the sun. The sun’s heat can scorch anddamage the shutter curtains.If you use the self-timer and bulb exposure in combination with a mirrorlockup, keep pressing the shutter button completely (self-timer delaytime + bulb exposure time). If you let go of the shutter button during theself-timer countdown, there will be a shutter-release sound, but nopicture will be taken.During mirror lockup, shooting function settings and menu operations,etc. are disabled.Even if the drive mode is set to continuous shooting, only one shot can be taken.You can also use the self-timer with mirror lockup.If 30 seconds elapse after the mirror has locked up, it will go back downautomatically. Pressing the shutter button completely again locks up themirror again.For mirror lockup, using Remote Switch RS-60E3 (sold separately) isrecommended (p.184).You can also use a remote controller (sold separately, p.184). Setting theremote controller to a 2-sec. delay is recommended.COPY
