Programming the Power WindowsIf the battery on the vehicle has been recharged,disconnected, or is not working, you will need toreprogram each front power window for the express-upfeature to work. Before reprogramming, replace orrecharge the vehicle's battery.To program each front window, follow these steps:1. With the ignition in ACC/ACCESSORY, ON/RUN,or when Retained Accessory Power (RAP) isactive, close all doors.2. Press and hold the power window switch until thewindow is fully open.3. Pull the power window switch up until the windowis fully closed.4. Continue holding the switch up for approximatelytwo seconds after the window is completely closed.The window is now reprogrammed. Repeat the processfor the other windows.Window Lockouto (Window Lockout): The rear window lockout buttonis located on the driver door near the window switches.Press the right side of the button to disable the rearwindow controls. The light on the button will illuminate,indicating the feature is in use. The rear windows stillcan be raised or lowered using the driver windowswitches when the lockout feature is active.To restore power to the rear windows, press the buttonagain. The light on the button will go out.Sun VisorsSwing down the visor to block out glare. The visors alsohave side-to-side slide capability.Lighted Visor Vanity MirrorPull the visor down and lift the cover to view the mirror.The light will come on when the cover is opened. It willgo out when you close the cover. If your vehicle has theadjustable lighting feature, slide the switch up or downto brighten or dim the light.3-17InformationProvidedby:
