177 ADAM-4000 Series User ManualChapter 6 Analog Output Module Commands40216.1.1 %AANNTTCCFFName Configuration commandDescription Sets address, input range, baud rate, data format, checksumstatus, and/or integration time for an analog output module.Syntax %AANNTTCCFF(cr)% is a delimiter character.AA (range 00-FF) represents the 2-character hexadecimaladdress that is to be configured.NN represents the new hexadecimal address of the analogoutput module. Range is from 00h to FFh.TT represents the type codes (output range codes).(See Table 6-2 on next page)CC represents the baud rate codes.(See Table 6-1 on next page)FF is a hexadecimal number that equals to 8-bit parameterrepresenting the status of data format, slew rate, andchecksum. The layout of the 8-bit parameter is shown in Figure 6.1.Bit 7 is not used and must be set to 0.(cr) is the terminating character, carriage return (0Dh).Figure 6.1 Data format for FF (8-bit parameter)Note! Only ADAM-4021 supports “% of FSR” and “two’s complement of hexadecimal” Data Format.
