89 ADAM-4000 Series User ManualChapter 4 Command Set4.3 I/O Module Commands Search TableTable 4.1: ADAM-4011 Command TableCommand Syntax Command Name Command Description Page No.%AANNTTCCFF ConfigurationSets the address, input range, baudrate, data format, checksum status,and/or integration time for a specifiedanalog input module5-4$AA2 Configuration Status Returns the configuration parametersfor the specified analog input module 5-10$AAF Read Firmware Ver-sionReturn the firmware version code fromthe specified analog input module 5-12$AAM Read Module Name Return the module name from thespecified analog input module 5-13#AA Analog Data InReturns the input value from a speci-fied analog input module in the cur-rently configured data format5-14$AA0 Span Calibration Calibrates an analog input module tocorrect for gain errors 5-19$AA1 Offset Calibration Calibrates an analog input module tocorrect for offset errors 5-20#** Synchronized Sam-plingOrders all analog input modules tosample their input values and storethem in special registers5-21$AA4 Read SynchronizedDataReturns the value that was stored inthe specified module's register afterthe #** command5-22$AA3 CJC Status Returns the value of the CJC sensorfor a specified analog input module 5-25$AA9SNNNN CJC Offset Calibra-tionCalibrates the CJC sensor for offseterrors 5-26@AADI Read Digital I/O andAlarm StatusThe addressed module returns thestate of its digital input channel, its twodigital output channels and the statusof its alarm5-50@AADO(data) Set Digital Output Set the values of the module's two dig-ital outputs (ON or OFF) 5-52@AAEAT Enable Alarm Enables the alarm in either Momentaryor Latching mode 5-54@AAHI(data) Set High Alarm Downloads the High alarm limit value 5-56@AALO(data) Set Low Alarm Downloads the Low alarm limit value 5-57@AADA Disable Alarm Disables all alarm functions 5-58@AACA Clear Latch Alarm The latch alarm is reset 5-59@AARH Read High Alarm The addressed analog input module isasked to return its high alarm value 5-60@AARL Read Low Alarm The addressed analog input module isasked to return its low alarm value 5-61@AARE Read Event Counter The addressed module is asked toreturn its event counter value 5-62@AACE Clear Event Counter The event counter is set to 0 5-63
