103 ADAM-4000 Series User ManualChapter 4 Command SetTable 4.16: ADAM-4024 Command TableCommand Syntax Command Name Command Description Page No.%AANNTTCCFF ConfigurationSet the address, output range, baudrate, data format, slew rate and/orchecksum status6-19#AACn(data) Analog Data Out Directs output data to a specifiedmodule 6-20#AASCn(data) Set Startup Data Set data As CHn StartUp Data 6-20#AAECn(data) Set Emergency Stop Set data As CHn Emergency StopData 6-20#** N/A Synchrous Sample IDI 6-20$AA0Cn 4 mA Calibration Tells the module to store parametersfor 4 mA Calibration 6-20$AA1Cn 20 mA Calibration Tells the module to store parametersfor 20 mA Calibration 6-20$AA2 Configuration Status Read back Module status 6-20$AA3Cn(number ofcounts) Trim Calibration Trims specified module a number ofunits up/down 6-20$AA4Start-up output cur-rent/voltage configu-rationStores a default output value in aspecified module. The output valuewill take effect upon startup.6-20$AA5 Reset Status Read Back Reset Times After Last$AA5 CMD And Clear This ounter 6-20$AA6Cn Last Value ReadbackReturns either last value sent to spec-ified module by #AA command, orstart-up output current/voltage6-20$AA7CnRxx Set Output Type Set CHn Output Type 6-20$AA8Cn Current ReadbackReturns measured value of the cur-rent/voltage flowing through currentloop6-21$AAF Read FirmwareVersionReturn the firmware version codefrom the specified analog outputmodule6-21$AAM Read Module Name Return the module name from thespecified analog output module 6-21$AAACnZ EMS Flag setting Enable/Disable (Z=1/0)CHn EMS Flag 6-21$AABCn Read EMS Flag Read CHn EMS Flag 6-21$AADCn Read startup data Read Back CHn StartUp Data 6-21$AAECn Read emergencyStopRead Back CHn Emergency StopData 6-21$AAG Reset Current Trim Reset Current Trim Data Variable To0 6-21$AAH Read Current Trim Read Current Trim Data Variable 6-21$AAI Read IDI Read IDI 6-21$AANCn Read 4mA Calibra-tion ParameterRead Back CHn 4mA CalibrationParameter 6-21$AAOCn Read 20mA Calibra-tion ParameterRead Back CHn 20mA CalibrationParameter 6-21
