Viewing and Configuring IP Services Settings 213b In the Organizer panel, click the plus sign next to the WX switch.c Click the plus sign next to System.d Select IP Services.e In the Task List panel, select DNS Server.4 Type the server address in the IP Address box.5 Select whether the server is primary or secondary.You can designate only one DNS server as the primary DNS server. Allother DNS servers are secondary servers.6 Click OK.7 In the Default DNS Domain box, type the default domain suffix that isappended to a hostname if the hostname cannot be resolved as entered.The suffix can be up to 64 characters long with no spaces or tabs.Configuring NTP You can configure a WX switch to use the Network Time Protocol (NTP)to automatically set the system date and time. NTP polls network timeservers at regular intervals and synchronizes the system date and timewith the servers. By default, NTP is not enabled. You can specify up tothree NTP servers.If NTP is configured on a system whose current time differs from the NTPserver time by more than 10 minutes, convergence of the WX time cantake many NTP update intervals. 3Com recommends that you set the timemanually to the NTP server time before enabling NTP to avoid asignificant delay in convergence.1 Access the Create NTP Server wizard:2 To change the interval at which an NTP server is polled, specify its value inseconds (16 to 1024) in the Update Interval box. The default is 64seconds.3 Access the Create NTP Server wizard:a Select the Configuration tool bar option.b In the Organizer panel, click the plus sign next to the WX switch.c Click the plus sign next to System.d Select IP Services.e In the Task List panel, select NTP Server.4 Type the server address in the IP Address box.
