184 CHAPTER 6: C ONFIGURING WX S YSTEM PARAMETERSTo remove an Auto DAP1 Select the Configuration tool bar option.2 In the Organizer panel, select the WX switch.3 In the Task List panel, select Remove Auto DAPs.The Remove Auto DAP wizard appears. The MAPs that were configuredusing a Distributed MAP template are listed.4 Select the Auto DAP that is no longer on the network.5 Click Next.6 Click Finish.Launching a TelnetManagement Sessionwith the SwitchThis option is available only if the switch is running and can be reachedthrough the network by 3WXM Services. This option also requires theManaged option for the switch to be enabled. (See step 6 in “ModifyingBasic Switch Parameters” on page 179.)1 Select the Configuration tool bar option.2 In the Organizer panel, select the WX switch.3 In the Task List panel, select Launch Telnet.Launching a WebManagement Sessionwith the SwitchThis option is available only if the switch is running and can be reachedthrough the network by 3WXM Services. This option also requires theManaged option for the switch to be enabled. (See step 6 in “ModifyingBasic Switch Parameters” on page 179.)1 Select the Configuration tool bar option.2 In the Organizer panel, select the WX switch.3 In the Task List panel, select Launch Browser.
