EtherTRAK®2 and Etherbus®Dual Ethernet I/O Module5 Module Wiring / Screw Terminal Assignments5.1 Screw Terminal GuidelinesThe screw terminals used on the E2-BASE-1 can accept 30 to 12 AWG wire. The screw size is M3 and the recommendedtorque is 5 IN/LB.The screw terminals used on the E2-BASE-TC-1(used in E2-16ISOTC-D only) can accept 30 to 16 AWG. The screw size isM2 and the recommended torque is 1.5 IN/LB.5.2 Typical I/O WiringThe sample wiring diagram below is mostly applicable for the combination I/O modules (E2/EB-MIX24880-D and E2/EB-MIX24882-D). The I/O wiring for discrete and analog inputs is representative of most other I/O modules. Isolated I/Owiring used in the E2/EB-16DI24-D, E2/EB-16DIAC-D and E2/EB-16DI24-D are also included.NOTE: The upper and lower screw terminal assignments for the E2-MIX-24882-D are shown in this diagram as anexample. For detailed information on Screw Terminal Assignments for this and all other module types, consult the tablesbelow or the help files in either the I/O Tool Kit software or the module’s web server.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
