EtherTRAK®2 and Etherbus®Dual Ethernet I/O Module2.2 Replacing the logic moduleThe logic module can be removed from the base in a system that is powered on (hot-swap). The modulemaybe removed and replaced with another one for troubleshooting or repair/replacement purposes. To removethe module first open the lock tabs on the top and bottom of the module as show in the picture below. Next,pull on the module from the middle as show in the picture below. To replace the module reverse this process.2.3 Base CoverThe screw terminals and communication ports may be covered by the base covered. The base cover isincluded with every module and must be used to comply with CE. To adjust the size of the holes for the wiringcot out the punch-out boxes with a sharp knife. Note: Do not attempt to push the punch-out boxes with hand.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
