Server FaxWorkCentre™ 5735/5740/5745/5755/5765/5775/5790Getting Started24Server Fax1. Load your documents face up in the document feeder input tray. Adjust the guide to touch thedocuments.Or...........Lift up the document feeder. Place the document face down onto the document glass and registerit to the arrow at the top right rear corner. Close the document feeder.2. Press the Clear All (AC) button once to cancel any previous screen programing selections.3. Press the Services Home button and select the ServerFax option. The Server Fax features are displayed.4. Enter the recipient’s fax number by:• Keypad Dial - select the Enter Number area onthe touch screen and enter the number using thenumeric keypad.• Fax Directory - Touch the Fax Directory button,select an entry from the Fax Directory to add tothe Recipient list.5. Select Add to add the number to the Recipient list.6. Select the required features for your fax job using the touch screen:7. Press Start to scan the originals and process the Server Fax job.Remove the originals from the document feeder or document glass when scanning has completed.Note: The Server Fax job enters the job list ready for sending.8. Select Job Status to view the job list and check the status of your job.For information about additional Server Fax features, refer to Sending a Server Fax on page 92 of Fax.Dialing Characters are alphanumeric characters which have a specific fax function and can beentered as part of the fax number.2-Sided Scanning is used to select whether your originals are 1-sided or 2-sided.Original Type is used to define the original document as text, text and photo, or photo.Resolution can be used to optimize the resolution settings.
