11 Setups182 Xerox Phaser 3635MFP User GuideChange Default SettingsChanging the user defaults to reflect the needs of the users will make themachine more user-friendly, increasing effectiveness and productivity.Set (Power Save) Duration TimesThis utility enables the System Administrator to modify the default 30 minutesthe machine will spend between standby and low power modes.The machine is designed to be energy efficient and will automatically reduceits power consumption after periods of inactivity.• To change the elapsed time for the machine to go from Standby Mode toLow Power Mode, select the appropriate time frame, e.g. after 5 minutesduration, after 45 minutes duration, etc.Select the Save button to confirm the change.Tools > Device Settings > General > Energy SaverEntry Screen DefaultThis feature enables the machine administrator to set which screen the usersees first.The Entry Screen appears when the machine resets selections after a userhas completed a job, or after the Clear All button is pressed. The availableoptions are Features, Job Status, Machine Status and All Services. To setone of the options, touch the appropriate button and then select Save.Tools > User Interface > General > Screen Defaults > Entry ScreenDefaultJob Status DefaultUse this feature to set the default screen when the user presses the JobStatus button to the left of the UI. For a full list of available screens, refer toJob Status Screen in the Copy chapter on page 41.Tools > User Interface > General > Screen Defaults > Job Status DefaultFeature Default and PriorityUse this feature to change the priority of the Copy, ID Card Copy, Fax andEmail features.The highest priority service will be displayed as the default service on themachine. The next two services will be displayed as buttons in the Features
