01/026-78825/8830 Printer Stepper Motor Commands, To Enter Multiple TestsGeneral ProceduresStepper Motor Commands To Enter Multiple Tests (Chaining)The Media button is used when entering more than one test. To chain one code to another,perform the following:1. Enter the desired code for the first test.2. Press the MEDIA button, then enter the additional code(s) for additional tests.Table 1Button Pressed Response0 Switches stepper motor OFF.1 Switches the stepper motor ON, in the forward direction, at the NVMrate for Bond media.2 Switches the stepper motor ON, in the forward direction, at the NVMrate for Vellum media.3 Switches the stepper motor ON, in the forward direction, at the NVMrate for Film media.4 Switches the stepper motor ON, in the reverse direction, at the currentNVM rate for reverse.5 Holds the stepper motor at the current position, low current.Next Makes the currently outputted stepper motor rate one count longer,slowing the actual feed rate.Previous Makes the currently outputted stepper motor rate one count shorter,increasing the actual feed rate.Enter Enters the currently outputted stepper motor rate into NVMExit Switches the stepper motor OFF and returns the printer to the TestEntry Mode.Media Does not affect the stepper motor, and returns the printer to the TestEntry Mode.
