Toshiba G3 Workbook

* For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-219257If you want to stop/start the slave from the keypad, set Frequency Mode Selection in UTILITYPARAMETERS to ‘1’ (remote input valid). This will allow the drive to follow an external frequencyreference even with the LOCAL/REMOTE LED illuminated.The follower’s pulse input can be bias/gained to set up a ratio between drives. To make the follower runhalf the speed of the master, program the following into the follower:Group Parameter ValueFUNDAMENTAL PARAMETERS Maximum Output Frequency 60FREQUENCY SETTING PARAMETERS PG Terminal Standard or Adjustable 1FREQUENCY SETTING PARAMETERS PG Reference Setting Point #1 0FREQUENCY SETTING PARAMETERS PG Ref Point #1 Frequency 0FREQUENCY SETTING PARAMETERS PG Reference Setting Point #2 100*FREQUENCY SETTING PARAMETERS PG Ref Point #2 Frequency 30* The Bias/Gain of the PG input is dependent on the drive’s Maximum Output Frequency (MOF). In theabove example, if the MOF is left at 80 Hz, the follower will run at 22.5 Hz when the master is at 60 Hz(the drive assumes MOF to be 100%).Because the permissible adjustment range of the above parameters includes positive and negative values, afollower direction change based on reference is possible.12VCCFPG3CC48,96, or 360 of these per output Hz persecond, as set by “FP” Output TerminalPulse Frequency in TERMINALSELECTION PARAMETERS group.