Toshiba G3 Workbook

* For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-2192219Programming the Input TerminalsIntroductionWhen the G3 is first taken out of the box, its terminals function in the same way the G2+’s did; the “F” terminalstarted a forward run when shorted to “CC”, the “R” terminal started a reverse run when shorted to “CC”, etc.Unlike the G2’s terminals, the G3’s terminals have programmable functions. All of the nine input terminals(twelve with the option board) can be programmed to activate one of fifty functions when shorted to “CC”.ConnectionsINPUT TERMINALCC S1 S2 S3 S4 F R RES STChoices for terminal functionValue Function Value Function01234567891011121314151617181920212223Reverse direction referencePreset speeds (1)Preset speeds (1)Preset speeds (1)Preset speeds (1)Forward direction referencereset ALL faultsdrive enableJOG (also need direction command) (7)select ACC1/DEC1 (open) or ACC2/DEC2 (closed)Emergency stop (11)DC injection (6) (when running at frequency under DCInj Start Freq, short terminal to ‘CC’ to inject)activate FUNDAMENTAL PARA #1 group (open) orFUNDAMENTAL PARA #2 group (closed)PID OFF (closed) or ON (open)select Pattern Run #1 (2)select Pattern Run #2 (2)select Pattern Run #3 (2)select Pattern Run #4 (2)Pattern Run continue signal (2)Pattern Run step signal (2)JOG forward (includes forward command) (7)JOG reverse (includes reverse command) (7)Bit #0 (MOF/2048) (3)Bit #1 (MOF/1024) (3)242526272829303132333435363738404142434950515354Bit #2 (MOF/512) (3)Bit #3 (MOF/256) (3)Bit #4 (MOF/128) (3)Bit #5 (MOF/64) (3)Bit #6 (MOF/32) (3)Bit #7 (MOF/16) (3)Bit #8 (MOF/8) (3)Bit #9 (MOF/4) (3)Bit #10 (MOF/2) (3)no function (use terminal to connect two wires)increase frequency reference (4)decrease frequency reference (4)clear frequency reference (4)momentary Start push button (5)momentary Stop push button (5)forward (open) or reverse (closed) run (5)RUN (use in conjunction with 40 above)binary data write (3)emulate LOCAL/REMOTE keyemulate RUN keyemulate STOP/CLEAR key (fault resettability will begoverned by setting of Panel Reset Selection in PANELCONTROL PARAMETER group)drive/bypass switching signal (8)give “RR” priority over IV and RX (9)give “IV” priority over RR and RX (10)