Samsung Officeserv 7100 Technical Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

Contents

OfficeServ 7100 SPECIAL APPLICATIONSTECHNICAL MANUAL PART 2 JANUARY 20092.8.12Set USER=VoIP Networking and choose the IP trunk members (MGI channels)to be used for this “Networking” use. The default values should start withmember 1 = 3801, etc.• MMC 820: Program the following values for LINK ID, SIGNAL G/W (enter theMP10/MP10a IP address for each node), and IP type for each node as follows(SELF refers to the current node you are programming):Index Link ID Signal G/W IP TypeSELF 091 192.168.1.2 PrivateSYS01 092 192.168.1.4 Private• MMC 724: Set up the numbering plans. Trunk group 803 will contain all the IPnetworking trunks.STN NUM PLAN Station numbers (2000 ~ 2099)TRKG NUMBER PLAN 803 (Add other trunk groups here if other trunk cardsare installed. For simplicity, only 803 will be addedhere.)FEAT Dial Number LCR 9 For C.O. outgoing calls, 9 + phonenumberNTWK LCR NUMPLAN IDX-01 : 21 Converted to 2100~2199 in MMC 824IDX-02 : 22IDX-03 : 23• MMC 210: Tenant On and Off: For LCR ENABLE: Set to ON to enable LeastCost Routing. Set ICM EXT FWD to ON.• MMC 824: Set up the extension dialing plan for the networked system (node B).092 is the node id for Node B. Be sure to set DISP=Y.Index Station Converted SZ Max MB DISP01 21 09221 4 7 N Y Stations in Node B02 22 09222 4 7 N Y03 23 09223 4 7 N Y• MMC 714:Entry Digit MOH 1~6 CW Delete Name001 20** - B - 0 -