Samsung OfficeServ 7100 Technical Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

OfficeServ 7100 PROGRAMMINGTECHNICAL MANUAL PART 2 APRIL 2007MMC: 837• INVITE LING TM: After the client sends ACK for the INVITE Final Response, theclient cannot confirm if the server received the ACK message. The client waits forthis amount of time after sending ACK for the Final Response. The range is0~99900.• PROVISIONAL TIME: After receiving the Provision Response, the User Agentshall wait for this amount of time until Timeout ends. The range is 0~999900.• INV.NO RESP TIME: Before sending Cancel for the Invite Request, the UserAgent shall wait for this amount of time. The range is 0~99900.• GEN.NO RESP TIME: Before sending Cancel for General Request, the UserAgent shall wait for this amount of time. The range is 0~99900.• REQ.RETRY TIME: After sending General Request, the User Agent shall wait forthe Final Response for this amount of time. The range is 0~99900.• SIP SERVER ENBLE: ENABLE or DISABLE to use an optional external industry-standard SIP Server.• SIP SERVER IP: Sets SIP server IP address.• SIP SERVER PORT: Sets the port to use on the SIP Server.• SIGNAL PORT: Indicate the port number for signaling and sets a range ofnumbers allowed by firewall equipment. The common/default IP path or portused is 10000• SEND CLIP TABLE: Refers to SEND CLI NUMBER (MMC 321), which providescalling party identification when using the MGI as a trunking gateway. Thisprovides station ID of the calling station. A single digit value corresponding withthe desired table in MMC 321 should be entered here. This is only used whenMMC 405 value is null.• INCOMING MODE: This option selects how incoming calls are routed:FOLLOW DID TRANS [default] (MMC 714), FOLLOW TRUNK RING (MMC 406),or FOLLOW INCOM DGT (MMC 724) when the MGI is used as a trunkinggateway.• REGISTER T-GW: Trunk gateway number to register STP server.• ALLOW GW CHECK: Enable the check for the presence of a gateway.• SIP REGISTERED: Displays registration status to the SIP server. (READ ONLY)