Samsung OfficeServ 7100 Technical Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

OfficeServ 7100 PROGRAMMINGTECHNICAL MANUAL PART 2 APRIL 2007MMC: 832 VoIP OUTBOUND DIGITSDESCRIPTION:This MMC is only used for Gateway to Gateway IP Trunking applications. This MMCprovides the means to set the MGI internal numbering plan for digit dialing andconversion when using IP trunking application.• ACCESS DGT: This is the access code that is used once the MGI is accessed;this directs a call based on the routing tables used. An access code table thenreferences an access code and correlates an IP address to the access code forrouting. A maximum of 8 digits are available with 63 access code entries(00~62).• DGT LENGTH: This field requests the number of digits that are expected to bereceived to make up the whole access code.• DEL.LENGTH: This is the number of digits to delete after receiving the accesscode.NOTE: If no digits are deleted the access code will be sent as part of the call tothe destination to continue routing at the far end destination.• INSERT DGT: This is the digit(s) to insert for routing at the destination. This canbe used when different numbering plans exist or if a dial 9 access is needed tobe inserted in the dialed digits.• IP TABLE 1: This is the first table referenced for routing the access code to anIP address The system has 63 IP tables (00~62) with 16 entries (00~15) in eachtable.• IP START: This entry indicates where in a table to start looking for an IP code toassociate with the access code.This can be used to manage where to startlooking for an IP address in high traffic MGI applications. Example: If IP addressrouting to the desired destination is known to be in the last 7 entries of a tablethe IP START location would be 8. IP address searching would start at entry 8.• SERVER USE: This parameter determines whether a H.323 Gatekeeper(MMC836) will be utilized to establish this connection (0:no, 1:yes).