SAMSUNG DCS PROGRAMMINGTECHNICAL MANUAL December 1996MMC: 714 DID NUMBER AND NAME TRANSLATIONDESCRIPTION:Provides a method of assigning a incoming DDI call to a specific station. If you registered DDIservice in your Local Exchange Network,you can match each DDI number to specific stationaccording to the day or night mode using this operation and you can give option ; whendestination station is busy,incoming call can be cleared or camp-on that station to alarm thatthere is another call. And there is an extra option to adjust the number of digits to be comparedby skipping the programmed counts from the first digit point privided by the Network.If there is no matching number in DID NUMBER TABLE,DCS system routes this call to operatorgroup.There are total 200 entries in the system and each entry consists of the following fields.0. DIGITS Digits to be received. Wild card(Q) is valid entry and 10 digitsmaximum.1. DAY DEST Destination in day mode and it could be a station, a station group, atrunk and trunk group. Repeat (B) will be acceptable to bypass.2. NIGHT DEST Destination in day mode and it could be a station, a station group, atrunk and trunk group. Repeat (B) will be acceptable to bypass.3. CALL WAIT Toggles YES or NO.4. NOF DEL DGT Decides the number of digits not to be translated from the first digitreceived. It is useful when the received digits are consist ofsubsequent numbers and prefixed with same-digit stream repeated.(i.e., non-significant digit).5. NAME Give name to an individual entry and 11 characters maximum.Names are written using the keypad in a same manner as SPEED NAME, refer to below table;COUNT 2 3 4 5 1DIAL 0 Q Z . ) 0DIAL 1 space ? , ! 1DIAL 2 A B C @ 2DIAL 3 D E F # 3DIAL 4 G H I $ 4DIAL 5 J K L % 5DIAL 6 M N O ^ 6DIAL 7 P R S & 7DIAL 8 T U V Q 8DIAL 9 W X Y ( 9DIAL Q : = [ ] QThe # key can be used for special characters: #, space, &, !, :, ?, ., %, $, -, <, >, /, =, [, ], @, ^, (, ),_, +, {, }, |, ;, \, " and ~.