Samsung DCS Programming Manual

Also see for DCS: User guide Programming manual Quick reference guide User guide Guide

SAMSUNG DCS PROGRAMMINGTECHNICAL MANUAL December 1996MMC: 105 STATION SPEED DIALDESCRIPTION:Allows the system administrator or technician to program the personal speed dial locationsassigned to a station. This must be done for single line telephones because these stations cannotaccess programming. Each station may have up to 50 locations or bins assigned to it in MMC606 Assign Speed Block. The speed dial bins are numbered 00–49. Each speed dial numberconsists of a trunk or trunk group access code followed by a separator and up to 18 digits to bedialed. These dialed digits may consist of 0–9, [ and #. If the system recognizes a valid trunk ortrunk group access number, it will automatically insert the separator.PROGRAM KEYSUP & DOWN Used to scroll through optionsKEYPAD Used to enter selectionsSOFT KEYS Move cursor left and rightSPK Used to store data and advance to next MMCHOLD Used to clear previous entryB Used to insert a flash code “F”C Used to insert a pause code “P”D Used to insert a pulse/tone conversion code “C”E Used to mask/unmask following digits (shows as “[” or “]”)F Used to enter name for speed dial bin (see MMC 106)ACTION DISPLAY1. Press TRSF 105Display shows[201] SPEED DIAL00 :2a. Dial station number (e.g. 205)OR[205] SPEED DIAL00 :Press UP or DOWN to select stationand press RIGHT soft key to move cursorORPress LEFT soft key to go to step 42b. If selected station has no speed dialbins, the display will be as shown and[205] SPEED DIALSPDBLK NOT EXISTa new station may be selected3. Dial location number (e.g., 05)OR[205] SPEED DIAL05: _Press UP or DOWN to select locationand press RIGHT soft key to move cursorORPress LEFT soft key to return to step 24. Enter trunk access code (e.g., 9)followed by the number to be dialed[205] SPEED DIAL05 : 9-4264100_