Qlogic SANbox 5600 Series User Manual

Also see for SANbox 5600 Series: Brochure Supplementary guide Supplementary guide Guidelines Supplementary guide

Contents

Qlogic SANbox 5600 Series User Manual Manual pdf 39 page image

2 – Using SANsurfer Switch ManagerSANsurfer Switch Manager User Interface59097-02 B 2-23A2.11.4Graphic WindowThe graphic window, shown in Figure 2-6, presents graphic information aboutfabrics and switches such as the fabric topology and the switch faceplate. Thewindow height can be adjusted by clicking and dragging the window border that itshares with the data window.2.11.5Data Window and TabsThe data window presents a table of data and statistics associated with theselected tab. Use the scroll bar to browse through the data. The window lengthcan be adjusted by clicking and dragging the border that it shares with the graphicwindow.Adjust the column width by moving the pointer over the column heading bordershared by two columns until a right/left arrow graphic is displayed. Click and dragthe arrow to the desired width.The data window tabs present options for the type of information to display in thedata window. These options vary depending on the display.2.11.6Working Status IndicatorThe working status indicator, located in the lower right corner of the SANsurferSwitch Manager window, shows when the management workstation is exchanginginformation with the fabric. As conditions change, the fabric forwards thisinformation to the management workstation where it is reflected in the variousdisplays.