4040Configure the settings relating to the priority stream [System]Click the [System] tab on the "User mng." page. (☞ Pages 13 and 14: How to display/operate the setup menu)The description below is the configuration of the priority stream that can transmit images without deteriorating theimage quality and refresh interval even when multiple users access concurrently.■ Priority stream[Activation]Select "On" or "Off" to determine whether or not to usethe priority stream.Default: OffNote:• When "On" is selected for "Activation" of "Prioritystream", number of users who can access the unitmay be limited.[Destination IP address (1)]Enter the first destination IP address.[Destination IP address (2)]Enter the second destination IP address.[Stream type]Select either "JPEG", "H.264(1)" or "H.264(2)".JPEG: JPEG images will be transmitted.H.264(1): H.264(1) images will be transmitted.H.264(2): H.264(2) images will be transmitted.Default: JPEG[Refresh interval*]Select the refresh interval from the following.This setting is validated only when "JPEG" is selectedfor "Stream type".0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/6fps*/ 10fps*/ 12fps* (PAL model)/ 15fps*/ 30fps*Default: 1fpsNote:• When "On" is selected for "H.264 transmission", therefresh interval may be longer than the set valuewhen any value with an asterisk (*) on the right isselected.[Image capture size]Select the image capture size from the following.When "4:3" is selected for "Aspect ratio"QVGA/ VGA/ 1280x960* 1When "16:9" is selected for "Aspect ratio"320x180/ 640x360/ 1280x720* 1This setting is validated only when "JPEG" is selectedfor "Stream type".Default: 1280×960*1VGA*2*1 SP105*2 SP102
