37Configure the settings relating to Panasonic alarm protocol[Notification]Click the [Notification] tab on the "Alarm" page. (☞ Pages 13 and 14: How to display/operate the setup menu)The settings relating to Panasonic alarm protocol can be configured in this section.■ Panasonic alarm protocol notification[Panasonic alarm protocol]Select "On" or "Off" to determine whether or not to pro-vide notification by e-mail according to the settings forthe "Alarm" checkboxes of "Destination of notification"below.• When an alarm is detected ("Alarm")Default: OffNote:• When "On" is selected, notification of the alarmoccurrence will be provided to the registered desti-nation addresses in order (to IP address 1 first, to IPaddress 8 last).[Destination port]Select a destination port for the Panasonic alarm proto-col from the following.Refer to the help window to infomation about theunavailable port number.Available range: 1 - 65535Default: 1818[Retry times]Select a retry time for the Panasonic alarm protocol.Available range: 0-30Default: 2■ Destination of notification[Address 1] to [Address 8]Enter the destination IP address of the Panasonic alarmprotocol from the following. Host name is unavailablefor the IP address. Up to 8 destination addresses canbe registered."Alarm" checkbox: When the checkbox is checked,the Panasonic alarm notification will be providedupon an alarm occurrence."Destination IP address" checkbox: Enter the desti-nation address.To delete the registered IP address, click the [Delete]button respective to the desired IP address.Important:• Confirm that the destination IP addresses are regis-tered correctly. When a registered destination doesnot exist, notification may be delayed.
