35Step 1Set the video motion detection area by dragging themouse on the screen.→ The designated area will become the VMD area"1(White)" and the outline will be displayed. When2 - 4 VMD areas are set, each area will be numberedin order. The areas will be identified by the respec-tive outline colors. The "Status" of the outline to beset for the area will become "On".Step 2Adjust "Detection area" and "Detection sensitivity"using the slider."Detection area" can be adjusted by moving the sliderbetween the left end position and the center position."Detection sensitivity" can be adjusted by moving theslider between the left end position and the right endposition.Refer to page 33 for further information about the"Detection sensitivity" and "Detection area".Note:• When "Detection area" cannot be adjusted properlyby moving the slider, adjust "Detection sensitivity"while checking the motion detection status.Step 3Click the [Set] button after completing the settings.Important:• The setting will not be applied unless the [Set] but-ton is clicked.Step 4To invalidate the VMD area, click the [Set] button afterselecting "Off" for "Status" of the VMD area to be invali-dated.→ The outline of the invalidated VMD area will turn to adotted line. When the VMD area is invalidated, noalarm will occur even when a motion can be recog-nized in the area.Step 5To delete the VMD area, click the [Delete] button corre-sponding to the area to be deleted.→ The outline of the respective VMD area will disap-pear.Step 6Click the [Setup] button.→ The edited settings will be applied.Set the VMD areas [VMD area]Set the areas to activate the VMD function.Important:• When the settings are being configured on the setup menu, sometimes the VMD function may not work cor-rectly.
