3636Configuration of the settings relating to the mail notification[Notification]Click the [Notification] tab on the "Alarm" page. (☞ Pages 13 and 14: How to display/operate the setup menu)The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail serverto perform the mail notification. (☞ Page 41)■ Mail notification[Mail server >>]When "Mail server >>" is clicked, the [Mail] tab of the"Server" page will be displayed. (☞ Page 41)[Mail notification]Select "On" or "Off" to determine whether or not to pro-vide notification by e-mail according to the settings forthe "Alarm" and "Diag." checkboxes of "Destination ofnotification" below.Default: Off[Alarm image attachment]Select "On" or "Off" to determine whether or not toattach an image to the mail to be sent.Default: OffNote:• The settings for "Image capture size" of the "Alarmimage" section on the [Alarm] tab (☞ page 32) willbe applied to the size of the image to be attached.■ Destination of notification[Address 1] to [Address 4]Enter the destination mail address. Up to 4 destinationaddresses can be registered."Alarm" checkbox: When the checkbox is checked,the mail notification will be performed upon analarm occurrence."Destination address": Enter the destination address.To delete the registered address, click the [Delete]button respective to the desired address.Available number of characters: 3 - 128 characters[Mail subject]Enter the mail subject.Available number of characters: 0 - 50 characters[Mail body]Enter the mail body.Available number of characters: 0 - 200 characters
