Panasonic WV-SP105 Operating Instructions Manual

Also see for i-Pro WV-SP102: Integration note Product catalog Comparison chart Specifications Datasheet

Contents

Panasonic WV-SP105 Operating Instructions Manual Manual pdf 10 page image

1010Action at an alarm occurrenceThe alarm action (camera action at an alarm occurrence) will be performed when the following alarms occur.Alarm typeVMD alarm: When motion is detected in the set VMD area, the alarm action will be performed.* VMD stands for "Video Motion Detection".Command alarm: When a Panasonic alarm protocol is received from the connected device via a network, thealarm action will be performed.Action at an alarm occurrenceDisplay the alarm occurrence indication button on the "Live" page. (☞ Page 8)The alarm occurrence indication button will be displayed on the "Live" page at an alarm occurrence.Important:• When "Polling(30sec)" is selected for "Alarm status update mode" (☞ page 18), the alarm occurrence indicationbutton will be refreshed in 30 second intervals. For this reason, it may take a maximum of 30 seconds until thealarm occurrence indication button is displayed on the "Live" page at an alarm occurrence.Transmit an image onto a server automaticallyAn alarm image can be transmitted at an alarm occurrence to the server designated in advance. The settingsrequired to transmit an alarm image to a server can be configured in the "Alarm image" section on the [Alarm] tab ofthe "Alarm" page (☞ page 32) and the [FTP] tab of the "Server" page (☞ page 41).Notify of alarm occurrences by e-mailAlarm mail (alarm occurrence notification) can be sent at an alarm occurrence to the e-mail addresses registered inadvance. Up to 4 addresses can be registered as recipients of the alarm mail. An alarm image (still picture) can besent with the alarm mail as an attached file. The settings for alarm mail can be configured in the "Mail notification"section on the [Notification] tab of the "Alarm" page (☞ page 36) and the [Mail] tab of the "Server" page (☞ page41).Notify of alarm occurrences to the designated IP addresses (Panasonic alarm protocol notification)This function is available only when a Panasonic device, such as the network disk recorder, is connected to thesystem. When "On" is selected for "Panasonic alarm protocol notification", the connected Panasonic device will benotified that the camera is in the alarm state. The settings for Panasonic alarm protocol can be configured in thePanasonic alarm protocol section of the [Notification] tab of the "Alarm" page. (☞ Page 37)