Panasonic TH-98LQ70U Operating Instructions Manual

Also see for TH-84LQ70U: Operating instructions

Panasonic TH-98LQ70U Operating Instructions Manual Manual pdf 69 page image

69English[OPTION CONTROL] screenClick [OPTION CONTROL] from the menu. Commandinput field for command control of the unit is displayed.COMMAND Enter a command. Use thesame command used for theserial control. (see page 21)RESPONSE Response from the unit isdisplayed.SEND Command is sent and run.Note● After the settings are changed, it may take a whileuntil the Display’s response is displayed.[NETWORK SETTING] screenClick [NETWORK SETTING from the menu. Varioussettings of a network can be set. For details of thesetting items, please check [LAN setup] in [Networksettings] of the unit. (see page 52)DHCP Set to [ON] when a DHCPserver is used, or [OFF] when itis not used.IP ADDRESS Enter an IP address.SUBNET MASK Enter a subnet mask.GATEWAY Enter a gateway address.PORT Enter the port number used forcommand control. The availablesetting range is 1024 - 65535.DUPLEX Set the connection speed of theLAN environment.NETWORK ID Set the ID to identify this unit.The available setting range is0 - 99.SAVE Save the each set value.Note● To use a DHCP server, make sure the DHCPserver is started.● While a DHCP server is used, [IP ADDRESS],[SUBNET MASK], and [GATEWAY] values cannotbe entered.● When the set values are changed successfully,[NETWORK SETTING CHANGED.] message andthe changed set items are displayed.[CHANGE PASSWORD] screenClick [CHANGE PASSWORD] from the menu. Passwordto access the Web Browser Control can be set. Whenthe password is changed in this screen, the passwordused for command control and the PJLink securityauthentication is also changed.OLDPASSWORDEnter the old password.NEWPASSWORDEnter the new password.NEWPASSWORD(RETYPE)Enter the password enteredin [NEW PASSWORD] forconfirmation.SAVE Save the new password.The confirmation screen isdisplayed. Click [OK] to changethe password.Note● The default password is [panasonic].● Up to 32 alphanumeric characters can be used fora password.● When the password is changed properly,[Password has changed.] message is displayed.