Panasonic TH-98LQ70U Operating Instructions Manual

Also see for TH-84LQ70U: Operating instructions

Panasonic TH-98LQ70U Operating Instructions Manual Manual pdf 45 page image

45EnglishScreensaver(For preventing image retention)Do not display a still picture, especially in 4:3 mode, forany length of time.If the display must remain on, a Screensaver should beused.ScreensaverStart10:00TimeMode OffSide panel Off■ Screensaver settingsScreensaver operationWhen the Screensaver is operating, the following 5patterns are displayed full screen for 5 seconds each,and it will be repeated.Black → Dark grey → Grey → Light grey → White →Light grey → Grey → Dark greyNote● When the Screensaver is operating, the screenbrightness will be reduced, but it is not a malfunction.To start Screensaver nowSelect [On] in [Mode].Select [Start] and press .● The menu screen will disappear and theScreensaver will be activated.ScreensaverStart10:00TimeMode OnNote● To stop the Screensaver under On, press the button or any buttons on the main unit.● When the display is turned off, the Screensaver willbe deactivated.To set interval of ScreensaverSelect [Interval] in [Mode].Set [Periodic time].● Press to change the time by 15 minutes.Set [Operating time].● Press once to change the time by 1 minute.Keep pressing down to change the time by 15minutes.ScreensaverStart10:00TimeMode IntervalPeriodic timeOperating time0:000:00Periodic timeDeactivated. Operating timeTo set start and finish time of ScreensaverSelect [Time designation] in [Mode].Set [Start time] and [Finish time].● Press once to change the time by 1 minute.Keep pressing down to change the time by 15minutes.ScreensaverStart10:00TimeMode Time designationStart timeFinish time0:000:00Note● Please set [Time] before setting [Start time] and[Finish time]. (see page 50)To turn the power off after ScreensaverSelect [Standby after SCR saver] in [Mode].Set [Screensaver duration].● Press once to change the time by 1 minute.Keep pressing down to change the time by 15minutes.Select [Start] and press .● Screensaver will be activated and the power willbe turned off (Standby) at the time set.ScreensaverStart10:00TimeMode Standby after SCR saverOperating time 0:00Note● [Screensaver duration] can be set from 0:00 to23:59.When this is set to [0:00], [Standby after SCRsaver] will not be activated.