27EnglishSelecting the input signalSelect the signals input to the unit.Press or .UnitINPUTMENUVOLENTER/+/-/Switches input every time the buttons are pressed.●Or, press , select the input withandpress to set.123456789HDMI1HDMI2HDMI3HDMI4DisplayPortDIGITAL LINKDVI-DPCSDI1SDI2SDI3SDI4INPUT1Input in HDMI 1 terminal (Supports 4K picture)*2Input in HDMI 2 terminal (Supports 4K picture)*3Input in HDMI 3 terminal*4Input in HDMI 4 terminal*5Input in DisplayPort terminal (Supports 4K picture)6Input in DIGITAL LINK terminal (Supports 4K picture)7Input in DVI-D IN terminal8Input in PC IN terminal9Displayed when the optional “3G-SDI Terminal Boardwith Audio” (TY-TBN03G) is connected.*: During 4K picture input, [HDMI1] - [HDMI4] may bedisplayed differently depending on the settings of[Setup] - [HDMI 4K Interface]. (see page 51)Note●Displays the signal name as set in [Input label]. (seepage 48)●Outputs the sound as set in [Audio input select] in the[Options] menu. (see page 57)●Input will not be switched unless [Input lock] is set to[Off]. (see page 58)●Image retention (image lag) may occur on the LCDdisplay panel when a still picture is kept on the panelfor an extended period. To prevent such a problem,using the screensaver is recommended. (see page45)RECALLIt is possible to check the setting status of input label,picture mode, etc.Press .Current setting status will be displayed.16:9Off timer90 minMemory name: MEMORY21Input label2Aspect mode (see page 29)3Audio input (see page 57)4Profile name (see page 40)5Off timer remaining time (see page 28)6Clock / Mute (see page 28)●When there is no signal to the selected input, [NoSignal] is displayed for about 30 seconds at the end.●To display the clock, set [Time], and then set [Clockdisplay] to [On]. (see page 50, 61)●You can set its position to be displayed with [Setup] -[OSD position]. (see page 51)