Panasonic TH-98LQ70U Operating Instructions Manual

Also see for TH-84LQ70U: Operating instructions

Panasonic TH-98LQ70U Operating Instructions Manual Manual pdf 12 page image

English12● Dispose the Power supply cord cap and packagingmaterials appropriately after taking out the items.Remote Control Batteries1. Pull and hold the hook, then open the battery cover.2. Insert batteries - note correct polarity (+ and -).AAA/R03/UM4 type3. Replace the cover.Helpful Hint● For frequent remote control users, replace oldbatteries with Alkaline batteries for longer life.Precaution on battery useIncorrect installation can cause battery leakageand corrosion that will damage the remote controltransmitter.Disposal of batteries should be in an environment-friendly manner.Observe the following precaution:1. Batteries shall always be replaced as a pair. Alwaysuse new batteries when replacing the old set.2. Do not combine a used battery with a new one.3. Do not mix battery types (example: “Zinc Carbon” with“Alkaline”).4. Do not attempt to charge, short-circuit, disassemble,heat or burn used batteries.5. Battery replacement is necessary when remotecontrol acts sporadically or stops operating theDisplay set.6. Do not burn or breakup batteries.7. Batteries must not be exposed to excessive heat suchas sunshine, fire or the like.Important notice when attaching thefixing brackets 98-inch modelWhen attaching the optional fixing brackets to 98-inchmodel, attach the stand hooks to the positions as shownin the picture below, in accordance with the types offixing brackets.Position to attach stand hookABCA: Ceiling-hanging bracket (Stand hooks are notneeded as supplied bolt is used for installation.)B: Wall-hanging bracketC: PedestalAbout EyeboltThis unit has one Eyebolt (M12) attached to themiddle of the upper part at the time of shipment. Wheninstalling, use this to pull up the unit. Also, if needed, usethe Eyebolt holes as shown in the picture below.Eyebolt mounting positionsEyeboltNote● Ask a qualified technician to carry out installation.● Do not use Eyebolts or screws other than the onessupplied with the unit.● After installing, remove the Eyebolt, and then closethe hole with the supplied Eyebolt cap.