Panasonic TH-98LQ70U Operating Instructions Manual

Also see for TH-84LQ70U: Operating instructions

Panasonic TH-98LQ70U Operating Instructions Manual Manual pdf 10 page image

English10Minimum distance:aab a: 10 cm(3 15/16 ”)b: 20 cm(7 29/32 ”)aCleaning and maintenanceThe front of the display panel has been speciallytreated. Wipe the surface of the display protectivepanel gently using only a cleaning cloth or a soft,lint-free cloth.• If the surface is particularly dirty, wipe with a soft,lint-free cloth which has been soaked in pure water orwater in which neutral detergent has been diluted 100times, and then wipe it evenly with a dry cloth of thesame type until the surface is dry.• Do not scratch or hit the surface of the panel withfingernails or other hard objects, otherwise thesurface may become damaged. Furthermore, avoidcontact with volatile substances such as insectsprays, solvents and thinner, otherwise the quality ofthe surface may be adversely affected.If the cabinet becomes dirty, wipe it with a soft, drycloth.• If the cabinet is particularly dirty, soak the cloth inwater to which a small amount of neutral detergenthas been added and then wring the cloth dry. Use thiscloth to wipe the cabinet, and then wipe it dry with adry cloth.• Do not allow any detergent to come into direct contactwith the surface of the Display. If water droplets getinside the unit, operating problems may result.• Avoid contact with volatile substances such as insectsprays, solvents and thinner, otherwise the quality ofthe cabinet surface may be adversely affected or thecoating may peel off. Furthermore, do not leave it forlong periods in contact with articles made from rubberor PVC.Usage of a chemical cloth• Do not use a chemical cloth for the panel surface.• Follow the instructions for the chemical cloth to use itfor the cabinet.Wired LANWhen setting up the Display at a place, whereelectric statistic occurs often, take a sufficient anti-static measure before start using.• When the Display is used at a location, wherestatic electricity occurs often, such as on a carpet,communications of the DIGITAL LINK and the wiredLAN are disconnected more often. In that case,remove static electricity and the noise source thatmay cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wired LAN.• In rare cases, the LAN connection is disabled dueto static electricity or noise. In that case, turn off thepower of the Display and the connected devices onceand then re-turn on the power. Connect the DIGITALLINK and the LAN.The Display may not work properly due to strongradio wave from the broadcast station or the radio.• If there is any facility or equipment, which outputsstrong radio wave, near the installation location, setup the Display at a location sufficiently far from thesource of the radio wave. Or, wrap the LAN cableconnected to the DIGITAL LINK terminal by usinga piece of metal foil or a metal pipe, of which isgrounded at both ends.DisposalWhen disposing the product, ask your localauthority or dealer about the correct methods ofdisposal.