Panasonic TH-85VX200W Operating Instructions Manual

Also see for TH-103VX200C: Service manual

Contents

Panasonic TH-85VX200W Operating Instructions Manual Manual pdf 56 page image

52Setup menuMake the various settings to use the network function.SaveSave the current network Setup. Each value set forDHCP, IP address, Subnet mask, and Gateway will besaved. If “NG” is displayed, check the same IP addressis not used within the same network.DHCP (DHCP client function)To obtain an IP address automatically using a DHCPserver, set this to “On”. If DHCP server is not used, setthis to “Off”.IP address (IP address display and setting)Enter an IP address if DHCP server is not used.Subnet mask (Subnet mask display and setting)Enter a subnet mask if DHCP server is not used.Gateway (Gateway address display and setting)Enter a gateway address if DHCP server is not used.PortSet the port number used for command control.The available setting range is 1024 – 65535.When the PJLink™ protocol is used, the port setting isnot necessary.LAN SpeedSet the connection speed of the LAN environment.Select the value from Auto, 10 Half, 10 Full, 100 Half or100 Full.Network IDSet the ID to identify this unit.The available setting range is 0 – 99.Control I/F SelectSet whether to control with RS-232C (serial) or LAN.When “LAN” is set, power is supplied to LAN circuit,and power indicator is lit orange under the condition ofpower “Off” with remote control (stand-by state).MAC addressDisplay the MAC address of this unit. However, the MACaddress is not displayed when the “Control I/F Select” isset to “RS-232C”.Notes:• To use a DHCP server, make sure the DHCP server is started.• Contact your network administrator for details on settings.Network SetupSignalExtended life settingsScreensaverInput labelComponent/RGB-in selectRGB3D SettingsNetwork Setup192.168. 0. 81024255.255.255. 0192.168. 0. 1IP addressDHCPNetwork SetupSaveSubnet maskGatewayPortAutoLAN Speed0Network IDRS-232CControl I/F Select--:--:--:--:--:--MAC addressOffDHCP, IP address, Subnet mask and Gateway settings1 Set DHCP.When “Off” is selected, IP address and other settings can be set manually.2 Select the item and press .3 Enter an address.I192.168. 0. 8IP address1 Use to select a digit.2 Use to change a number or input thenumerical value from to .3 Press .Pressing will cancel the address change.4 Select “Save” and press .Port setting1 Select “Port” and press .2 Enter a port number.I01024Port1 Use to select a digit.2 Use to change a number or input thenumerical value from to .3 Press .Pressing will cancel the port number change.2 access1 select