38Picture ProlesOnce a prole is locked, the following operations are restricted when the prole is loaded.Setting Editing the Prole(Memory edit)Editing Picture AdjustmentValues via the Menu(Picture menu, Advancedsettings)Saving Picture Adjustment Values(Memory save)Off (unlocked) Allowed Allowed AllowedLock1 Prohibited Prohibited (picture adjustmentvalues are shown)AllowedLock2 Prohibited Prohibited (picture adjustmentvalues are hidden)ProhibitedNote:Make a note of the new password to remember it.Locking prolesYou can lock saved proles to restrict operations when the proles are loaded. You can also set passwords.Notes:• When the lock is set in “Extended life settings”, prole cannot be locked.• If prole is locked, the menu operations of “Extended life settings” are restricted. (see page 49)1 Display the menu screen.2 Select “Options” and hold for 3 seconds ormore.SetupPos. /SizeSoundOptionsPicture 2 access(3 secondsor more)1 select3 Select “Memory lock”.OnOnscreen displayOffAll AspectManualAuto SetupOffStudio mode3D settingsFunction button assign 1INT3D EmitterSignalFunction button assign 2On3D Safety PrecautionsMemory lock2 access1 select4 Enter a 4-digit password.The default password is“0123”.5 Select “Ok”.Ok CancelInput password1 select2 set6 Select the prole and specify the desired locksetting.Lock1Change passwordMEMORY1OffOffMEMORY2MEMORY12Offisf Mode2 adjust1 select7 Exit the menu.1 Follow steps 1–5 in the previous procedure, and unlocking proles>.2 Select “Change password”.Lock1Change passwordMEMORY1OffOffMEMORY2MEMORY12Offisf Mode2 access1 select3 Enter a new 4-digit password.4 Select “Ok”.Input new passwordOk Cancel1 select2 OK5 Exit the menu.