20Viewing 3D imagesYou can enjoy viewing 3D images with contents or programmes corresponding to the 3D effect by wearing the3D Eyewear (supplied).This display supports “Frame Sequential* 1 ”, “Side by Side* 2 ” and “Top and Bottom* 3 ” 3D formats.*1: The 3D format that the images for the left and right eyes are recorded with the high denition quality and alternately played back*2, *3: Other available 3D formats3D Eyewear set3D Eyewear Specialised bandNose pad A Nose pad B 3D Eyewear case• Use either nose pad A or B for your preference.• 3D Eyewear can be worn over vision correction glasses.Part names and functions3D EyewearInfrared receiverReceives infrared signals from the display.• 3D Eyewear is controlled by receiving infrared signals from the display, which allows you toview 3D images.Note:Do not soil the infrared receiver section or attach stickers etc. to it.Battery coverWhen using for the rst time, remove the insulating sheet.Insulating sheetPull the insulating sheet• To replace the battery “Replacing the battery” (see page 21)Specialised band attaching partsIf required, attach the specialised band.• To attach the band“Attaching the specialised band” (see page 21)Lenses - Liquid Crystal ShutterControls the images for 3D viewing.• The left and right liquid crystal shutters arealternately opened and closed in time withthe images on the display screen to achievethe 3D effect.Note:Do not apply pressure to or scratch thesurface of the liquid crystal shutter.Power button of the 3D Eyewear(bottom side of the 3D Eyewear)Switches the 3D Eyewear on or off.• Press the button for about 1 second to turn the power on. Theindicator lamp lights for about 2 seconds and then goes off.• To turn the power off, press the button for about 1 second again.The indicator lamp ashes 3 times, then the 3D Eyewear turns off.Note:If the 3D Eyewear does not receive any signals from the display forabout 5 minutes, the 3D Eyewear will be turned off automatically.Nose pad installation sectionIf required, attach the nose pad.• To attach the nose pad “Attaching the nose pad” (see page 21)Power buttonIndicator lamp