79Options AdjustmentsRS-232C/LAN Information TimingSet up the informing manner for no signal or temperature rising.While RS-232C controls: Warning or error message sent on the display atuomatically.While LAN controls: Acquire the warning or error message from the display.RS-232C/LAN Information TimingNo Signal WarningNo Signal Warning Timing 5minOn10minOnNo Signal ErrorNo Signal Error TimingTemperature WarningTemperature Warning ValueTemperature Warning Release ValueOn55°C52°CPress ACTION ( ) buttonOptions 2/3Off-timer functionInitial Power Mode NormalOffOffOffEnableRemote ID0ID selectSerial IDStudio W/BLAN Control ProtocolRS-232C/LAN Information TimingProtocol 11 select2 adjustNo Signal WarningIf set to “On”, the display sends out the no signal warning.No Signal Warning TimingSet up the detecting time for no signal warning.No Signal ErrorIf set to “On”, the display sends out the no signal error.No Signal Error TimingSet up the detecting time for no signal error.The warning of “No Signal Warning” and the error of “No Signal Error” are not sent when the no signal state isdetected through any of the following functions:No Signal power off: Enable, PC Power management, DVI-D Power management, HDMI1 Power management,HDMI2 Power management (see page 63)Setting ExampleNo Signal Warning Timing: 5 minutesNo Signal Error Timing: 10 minutesPC Power management: On (30 seconds)If there is no signal when PC IN is input, “PC Power management” is activated rst and the Display enters thestandby mode.Note:The “No Signal Error Timing” cannot be set shorter than “No Signal Warning Timing”.Temperature WarningIf set to “On”, the display sends out the warning temperature.Temperature Warning ValueSet up the detecting temperature for temperature warning.Temperature Warning Release ValueSet up the temperature to release the temperature warning.