Panasonic TH-80LFB70U Operating Instructions Manual

Also see for TH-50LFB70E: Operating instructions Operating instructions

Contents

Panasonic TH-80LFB70U Operating Instructions Manual Manual pdf 17 page image

67891345 215(Male)SERIAL Terminals connectionNotes:• Use the RS-232C straight cable to connect the computer to the Display.• The computer shown is for example purposes only.• Additional equipment and cables shown are not suppliedwith this set.The SERIAL terminal conforms to the RS-232C interfacespecication, so that the Display can be controlled by acomputer which is connected to this terminal.The computer will require software which allows thesending and receiving of control data which satises theconditions given below. Use a computer application suchas programming language software. Refer to thedocumentation for the computer application for details.The SERIAL terminal is used when the Display is controlled by a computer.Pin layout for SERIAL TerminalBasic format for control dataThe transmission of control data from the computerstarts with a STX signal, followed by the command, theparameters, and lastly an ETX signal in that order. Ifthere are no parameters, then the parameter signal doesnot need to be sent.STX C1 C2 C3 P1 P2 P3 P4: P5 ETXStart(02h)3-charactercommand (3 bytes)Colon Parameter(s)(1 - 5 bytes)End(03h)Notes:• If multiple commands are transmitted, be sure to wait forthe response for the rst command to come from this unitbefore sending the next command.• If an incorrect command is sent by mistake, this unit willsend an “ER401” command back to the computer.• S1A and S1B of Command IMS are available only whena dual input terminal board is attached.• Consult your local Panasonic dealer for detail instructionson command usage.Communication parametersSignal level RS-232C compliantSynchronization method AsynchronousBaud rate 9600 bpsParity NoneCharacter length 8 bitsStop bit 1 bitFlow control NoneSignal names for D-sub 9P connectorPin No. Details2 R X D3 T X D5 GND4 • 6 Non use78 (Shorted in this set)1 • 9 NCThese signal names are those of computer specications.ConnectionsCommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFAVL ** Volume 00 - 63AMT 0 Audio MUTE OFF1 Audio MUTE ONIMS NoneSL1S1AS1BVD1YP1HM1HM2DV1PC1DL1MG1MV1WB1Input select (toggle)SLOT input (SLOT INPUT)SLOT input (SLOT INPUT A)SLOT input (SLOT INPUT B)VIDEO input (VIDEO)COMPONENT/RGB IN input(COMPONENT)HDMI 1 input (HDMI1)HDMI 2 input (HDMI2)DVI-D IN input (DVI)PC IN input (PC)DIGITAL LINK input (DIGITAL LINK)Miracast input (Miracast(TM))Memory veiwer input(MEMORY VIEWER)WhiteBoard input (WHITEBOARD)With the power off, this display responds to PONcommand only.Note: To use serial control for this unit, make sure to set the “Control I/F Select” in the “Network Settings” menu to“RS-232C”. (refer to “Operating Instructions, Network Operations”)(Female)RS-232C Straight cableCOMPUTERD-sub 9p