31Memory Viewer FunctionInserting the USB memoryInsert the USB memory to the USB (VIEWER) port on the side of the display.Notes:When inserting the USB memory, conrm the direction of the plug not to damage the terminal.•Please note following points to insert and remove the USB memory.•The indicator of the inserted USB memory will be blinking while the display is reading out the data. Do not•remove the USB memory while it is blinking.When using a USB memory without indicator, you cannot recognize when the display is reading out the data.•Please remove it from the display after closing the Memory Viewer function or turning off the display.Do not insert and remove the USB memory frequently. Remove the USB memory at least 5 seconds after•insertion. And insert at least 5 seconds after removal. The display needs some time to detect insertion orremoval of the USB memory.Caution on handling and storing the USB memoryDo not put USB memory or its cap within close reach of children. Swallowing it may cause suffocation.•If the smoke or questionable odor rises, remove the USB memory from the equipment and contact the manufac-•turer.Do not put water, chemical or oil to the USB memory. It may cause short out or re.•Do not put foreign objects or put metal objects to the USB terminal. Static electricity may cause data loss or data•corruption.Do not remove the USB memory from the computer or the display while the USB memory is reading out or writing•the data. It may cause data loss or data corruption.Do not store the USB memory in hot, humid or dusty place or near magnetized items.•Notes:During accessing to the USB memory, do not turn off the power or remove the USB memory because the data in•the USB memory might get damaged. During accessing, the USB memory is blinking.The USB memory allows you to insert or remove regardless of the power status of the display.•USB(TOUCH)USB(VIEWER)USB MEMORYUSB(VIEWER)