Panasonic TH-65VX300ER Operating Instructions Manual

Also see for TH-65VX300ER: Service manual

Contents

Panasonic TH-65VX300ER Operating Instructions Manual Manual pdf 62 page image

62Using FUNCTION buttonAssigning functions to the FUNCTION button on the remote control enables a user to switchbetween show/hide and modes with just a single touch of a button. The function settings arecon¿gured by using “Function Button Settings” in the Setup menu (see page 57). The buttonfunctions are con¿gured in two ways depending on the setting (On/Off) of “Studio mode” in theOptions menu.The factory preset functions are as described below.Function Button 1: 3D SettingsFunction Button 2: SignalFunction Button 3: Colour gamutFunction Button 4: Scrolling barDisplay of the FUNCTION button guidePressing the FUNCTION button can display the FUNCTION button guide to refer for the functionof each button.If the guide display is not needed, set “Function Button Guide” in “Function Button Settings” to “Off” (see page 57).The operation starts.Function1: 3D Settings 2: Signal 3: Colour gamut 4: Scrolling bar3D Settings / Signal / Colour gamutThe menu screen is displayed.(Example: 3D Settings)On3D FunctionOnAuto3D Picture Format3D Settings3D Colour CompensationNormal3D Picture Sequence3D3D Viewing ModeSafety PrecautionsPressing the FUNCTION button clears the menu.Scrolling bar / Test PatternsCon¿rmation screen (Example: Scrolling bar)Yes NoFunctionScrolling barScrolling barActivates the “Scrolling bar only” screensaver. After15 minutes, the display enters standby mode.To exit this mode, press any button.Note:“PC Power management” and “No signal power off” are deactivated during “Scrolling bar” or “Test Patterns”operation. (see page 43)Press to select“Yes”.Press.Test PatternsEach time you press , a different test pattern is displayed(seven in all).Colour Bars Red GreenBlueFrame(2 lines × 2 dots)Black 1% windowTo exit this mode, press any button other than .The operation starts.