Panasonic TH-65VX300ER Operating Instructions Manual

Also see for TH-65VX300ER: Service manual

Contents

Panasonic TH-65VX300ER Operating Instructions Manual Manual pdf 45 page image

453D SettingsTo view the 3D images, please adjust and setup the 3D settings.Note:Set these settings for each input terminals.• 3D FunctionOn OFFOn: To view the 3D images, please set it to “On”. You can see 3D images for 3D image signal and 2D images for2D image signal.Off: You can see 2D images instead of 3D images.When set to “On”, “3D” is displayed during 3D images.• 3D Picture Format3D images method is set.Auto: 3D images are automatically displayed according to the signal.Simultaneous: Set this format when selecting a slot that one of the following terminal boards is installed:Dual HD-SDI Terminal Board for 3D (TY-FB30DHD3D), Dual DVI-D Terminal Board for3D (TY-FB30DD3D)Side by Side/Top and Bottom: One of the formats of the 3D standard. Select these formats as necessary.Native: Displays the input signal as it is. Use to identify the format type of the input signal.• 3D Viewing ModeThe 3D images are separated and displayed as right and left images.3D: Normal 3D images display (initial setting)Comparison: Left image (L) and right image (R) are placed side by side. If the 3D system is “Top and Bottom”, theimages are displayed, being set one above the other.Left: Only the left image (L) is displayed.Right: Only the right image (R) is displayed.3D Comparison Left RightNotes:• This function is disabled during 2D images.• The factory default setting is “3D”. To view the 3D images, please use “3D”.• 3D Picture SequenceReverse NormalThis function calibrates the timing to switch the right and left images as well as the timing to switch the shutter ofright and left 3D Eyewear.Select “Reverse” if you feel that the sense of depth is unusual.• 3D Colour CompensationOn OffThe colour adjustment during the 3D images is set.On: The colour when using the 3D Eyewear is adjusted. (initial setting)Off: The colour when using the 3D Eyewear is not adjusted. The 2D image setting is used.Note: The factory default setting is “On”. To view the 3D images, please set it to “On”.• Safety PrecautionsDisplays the precautions for viewing 3D images.2 access1 select 2 change1 selectSetup menuSelect the item and set.PCNANODRIFT16:93DSignalWaveform MonitorMarker settingsRGB/MONO settingsExtended life settingsScreensaverNetwork SetupInput labelFunction Button SettingsOn/Off Timer SetupDay/Time SetupComponent/RGB-in selectRGB3D SettingsOn3D FunctionOnAuto3D Picture Format3D Settings3D Colour CompensationNormal3D Picture Sequence3D3D Viewing ModeSafety Precautions