Panasonic TH-65VX300ER Operating Instructions Manual

Also see for TH-65VX300ER: Service manual

Contents

Panasonic TH-65VX300ER Operating Instructions Manual Manual pdf 46 page image

46AutoSync1024 ×76833.7 kHz60.0 Hz1125(1080)/60iXGA ModeH-Freq.V-Freq.Signal FormatSignal [ RGB ]MidFRAME CREATIONAuto33.7 kHz60.0 Hz1125(1080)/60iXGA ModeH-Freq.V-Freq.Signal FormatSignal [ Component ]On3D Y/C Filter (NTSC)AutoColour systemSignal [ AV ]Signal [ Digital ]MidFRAME CREATION33.7 kHz60.0 Hz1125(1080)/60iH-Freq.V-Freq.108.0 MHzDot Clock Freq.Signal FormatNote:“Signal” setup menu displays a different setting condition for each input signal.Signal menuFor Video (S VIDEO) For RGBFor ComponentFor Digital(Example: HDMI input)Setup menuExternal scaler modePower save OffOffSignalWaveform MonitorMarker settingsRGB/MONO settingsExtended life settingsScreensaverNetwork SetupInput labelFunction Button SettingsOn/Off Timer SetupDay/Time SetupComponent/RGB-in selectRGB3D SettingsInput signal displayDisplays the frequency and the type ofthe current input signal.This display is valid only forComponent / RGB / PC and Digital input signal.Display range:Horizontal 15 - 110 kHzVertical 48 - 120 HzThe dot clock frequency is displayed during DVI signal input.2 access1 selectSelect the item and set. 2 change1 select• 3D Y/C Filter (NTSC)This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.Set this menu when the moving image looks unnatural during Video (S Video) input signal.On OffNote:When On, this setting only affects NTSC input signals.• Colour systemThis menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.Auto SECAM M.NTSC NTSCPALSet the colour system to match the input signal. When “Auto” is set, Colour system will be automatically selectedfrom NTSC/PAL/SECAM /M.NTSC.To display PAL60 signal, select “Auto” or “PAL”.If the picture image becomes unstable:With the system set on Auto, under conditions of low level or noisy input signals the image may in rare casesbecome unstable. Should this occur, set the system to match the format of the input signal.• XGA ModeThis menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGAsignals with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz,1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).Auto 1024×768 1280×768 1366×768Auto: Automatically selected from 1024×768/1280×768/1366×768.Switch the setting to suit the input signal for better display depends on the angle of view or display resolutioncondition.Note:After making this setting, be sure to make each adjustment (such as “Auto Setup”) on the “Pos. /Size” menu asnecessary. (see page 25)