Panasonic TH-65VX300ER Operating Instructions Manual

Also see for TH-65VX300ER: Service manual

Contents

Panasonic TH-65VX300ER Operating Instructions Manual Manual pdf 48 page image

48Setup menuWaveform MonitorThe input signal from video equipment is displayed as waveforms so that the signal level can be checked.Notes:• This function is enabled when “Studio mode” in Options menu is set to “On”.• This function is disabled during 3D images.• Applicable input signal; HDMI, DVI, SDIOffWaveform MonitorOnTime out (5 min)Waveform Monitor2 access1 selectSelect the item and set.2 change1 selectExternal scaler modePower save OffOffSignalWaveform MonitorMarker settingsRGB/MONO settingsExtended life settingsScreensaverNetwork SetupInput labelFunction Button SettingsOn/Off Timer SetupDay/Time SetupComponent/RGB-in selectRGB3D Settings• Waveform MonitorOn: The waveform monitor is displayed.Off: The waveform monitor is not displayed.• Time out (5 min)The waveform monitor display time-out is set.On: The display of the waveform monitor disappears in5 minutes.Off: The waveform monitor display time-out does not occur.Display of the waveform monitor1 Set “Waveform Monitor” to “On”.The waveform monitor can also be displayed using the FUNCTION button on the remote control (see page63).2 Exit the menu.3 Press to switch the display mode.Notes:• The display mode and display position of the waveformmonitor are stored.• The aspect is ¿xed as “16:9” during the waveformmonitor display.Full scan modeThe display position of the waveform monitor can be changed with the cursor button.ExitMonitor PositionMode ChangeOperation guideSingle line scan modeScan line can be changed with the cursor button.100% YY50%0%100%50%0%Scan lineOperation guideExitScan Line PositionMode Change4 Press to exit the waveform monitor.The waveform monitor ends after 5 minute time-out or by setting “Waveform Monitor” to “Off”.Full scan (Y) Single line scan (B)Full scan (R) Single line scan (G)Full scan (G) Single line scan (R)Full scan (B) Single line scan (Y)