57Setup menuThe input label changes as follows each time the Ż or Ź button is pressed.(Skip) : The INPUT button press will skip its input.This function can change the label of the Input signal to be displayed. (see page 18)Customizing the Input labelsNote:The setting items are the same as the input terminal list of“Selecting the input signal” (page 18).2 access1 selectSelect an input terminal and set.2 change1 selectBlu-ray3Blu-ray2Blu-ray1OriginalCATVVCRSTBDVD2DVD1 DVD3(Skip)DVD4Blu-ray4SignalWaveform MonitorMarker settingsRGB/MONO settingsExtended life settingsScreensaverNetwork SetupInput labelFunction Button SettingsOn/Off Timer SetupDay/Time SetupComponent/RGB-in selectRGB3D SettingsSLOT INPUTSLOT INPUTInput labelCOMPONENTCOMPONENTHDMI1HDMI1HDMI2HDMI2PCPCSet the function to operate when the FUNCTION button 1 to 4 on the remote control is pressed.Using FUNCTION button page 62Function Button SettingsFunction Button 1SignalFunction Button 2Colour gamutFunction Button 3Scrolling barFunction Button 4OnFunction Button Guide3D Settings2 access1 selectSelect the item and set.2 change1 selectSignalWaveform MonitorMarker settingsRGB/MONO settingsExtended life settingsScreensaverNetwork SetupInput labelFunction Button SettingsOn/Off Timer SetupDay/Time SetupComponent/RGB-in selectRGB3D SettingsNote:The button functions are con¿gured in two ways dependingon the setting (On/Off) of “Studio mode” in the Optionsmenu.• Function Button 1 - Function Button 4The following functions are set to the FUNCTIONbutton.Function Button SettingsWaveform Monitor*Marker settings*HV Delay*Blue only3D SettingsSignalColour gamutScrolling barR On/OffG On/OffB On/OffMONOTest PatternsVolume +Volume -Mute* “Waveform Monitor”, “Marker settings” and “HV Delay” can beset when “Studio mode” in Options menu is “On”.• Function Button GuideThe function display setting for the FUNCTION buttonis con¿gured.On: Press the FUNCTION button to display thefunction list of the button.Off: The function list is not displayed.