Panasonic TH-65VX300ER Operating Instructions Manual

Also see for TH-65VX300ER: Service manual

Contents

Panasonic TH-65VX300ER Operating Instructions Manual Manual pdf 26 page image

26Adjusting Pos./SizeƔ Auto Setup When inputting a PC signal as an example, “H-Pos/V-Pos”, “H-Size/V-Size”, “Dot Clock” and“Clock Phase” are automatically corrected.This setting is enabled under the following conditions:• When inputting an analog signal (Component/PC):This setting is enabled if “Component/RGB-in select” (see page 41) in Setup menu is “RGB”.• When inputting a digital signal (HDMI/DVI):A PC format signal enables this setting.When the signal is not PC format, this setting is enabled only if “Over Scan” (see page 27) is“Off” or “1:1 Pixel Mode” (see page 27) is “On”. “H-Size/V-Size” is not automatically adjusted.This setting will be invalid and will not work under the following conditions:• When VIDEO signal input• Aspect is set to “Just”• “Display size” in the Options menu (see page 61) is set to “On”Using Remote ControlWhen on the remote control is pressed, “Auto Setup” will be executed.When Auto Setup does not work, “Invalid” is displayed.Auto modeWhen the “Auto Setup“ is set to “Auto” in the Options menu (see page 61), automatic positionadjustment starts:• When the display power is turned ON.• When the input signal is switched.Ɣ H-Pos Adjust the horizontal position. Ɣ V-Pos Adjust the vertical position.Ɣ H-Size Adjust the horizontal size. Ɣ V-Size Adjust the vertical size.Ɣ Dot Clock (During Component/PC input signal)Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If thishappens, adjust so that any such noise is minimized.Ɣ Clock Phase (During Component/PC input signal)Eliminate the Àickering and distortion.Notes:• If the dot clock frequency of an analog signal is 162 MHz or higher, “Dot Clock” and “ClockPhase” cannot be automatically corrected.• When digital signal input, Dot Clock and Clock Phase cannot be made.• Auto Setup may not work when a cropped or dark image is input. In such case, switch toa bright image with borders and other objects are clearly shown, and then try auto setupagain.• Depending on the signal, out of alignment may occur after Auto Setup. Carry out ¿ne tuningfor the position/size as required.• If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA Mode”(see page 46) may results in correct Auto Setup.• Auto Setup does not work well when a signal such as additional information is superimposedout of valid image period or intervals between synchronizing and image signals are short, orfor image signal with tri-level synchronizing signal added.• If Auto Setup cannot adjust correctly, select “Normalise” once and press OK button, thenadjust Pos. /Size manually.