24Helpful Hint ( Normalisation)If the N button on the remote control unit is pressed when the “Picture” menu is displayed, all adjustment values willbe returned to the factory setting level of each picture mode.N1.Push the “Menu” Button.2.Select the “Picture” Menu by pushing thePosition Up “F” or Down “G” Button andAccess the “Picture” Menu by pushing the“STR” Button.3.Select the required function by pushing thePosition Up “F” or Down “G”buttons, andaccess and alter the setting by pushing thePosition Left “I” or Right “H” buttons.Note:(1) You can change the level of each Function(Picture Mode, Colour, Tint, Brightness,Contrast, Sharpness, White balance) for eachpicture Menu.(2) The setting details for normal and dynamicrespectively are memorised separately for fivetypes of input signal format (NTSC, PAL,SECAM, 1080i and RGB/PC). (NTSC includes525i and 525p (480p) signals, and PALincludes 625i signals.)Note:(1) The “Tint” setting can be adjusted for NTSCsignal only.(2) “Colour”, “Tint” and “Sharpness” settingscannot be adjusted during “RGB” and “PC”input signal modes.(3) If the “Manual W/B” setting is changed to ONand the Position Down “G” button is pressed,the “Manual W/B” menu will be displayed.(Refer to page 25.)(4) The adjustment range values should be usedas an adjustment reference.Picture Mode FunctionNormal For viewing in normal (evening lighting)environments.This menu selects the normal levels ofBrightness and Contrast.Dynamic For viewing in brighter environments.This menu selects a higher than normallevels of Brightness and Contrast.Item Effect Adjustment rangePictureMode Normal / DynamicColour -30 30Tint(NTSC only) -30 30Brightness -15 15Contrast -30 30Sharpness -15 15Whitebalance Warm / Normal / CoolManual W/B Off / OnPictureSoundSignalSet upAccessSelect SelectAdjustPictureNormalPicture ModeManual W/BWhite balanceSharpnessContrastBrightnessTintColourDynamicWarmOff OnMENUExit0030001,2 3MENUSTRLess MoreReddish GreenishDarker BrighterLess MoreLess MorePicture Menu