Panasonic TC-42PD1FA Operating Instructions Manual

Also see for TC-42PD1FA: Service manual

Panasonic TC-42PD1FA Operating Instructions Manual Manual pdf 18 page image

18ASPECT Controls1 ASPECT-AUTO Button (Panasonic Auto)Press the ASPECT-AUTO button to switch toPanasonic Auto mode. The display willautomatically become enlarged.Note:(1) If an S1 signal is detected while Panasonic Auto mode isactive, the aspect mode will change to “16:9”.(2) If a 525p or 1080i signal is input during Component inputsignal mode and during RGB and PC input signal mode thecontrols will not operate.2 ASPECT-MANUAL buttonThe aspect mode changes each time theASPECT-MANUAL button is pressed.Note:(1) During RGB and PC input signal mode, the mode switchesbetween “4:3” and “16:9” only.(2) For a 525p (480p) signal input during “Component” inputsignal mode, the mode switches between “Zoom1” and“16:9” only.(3) When an S1 signal is being received during “S-Video” inputsignal mode, the mode is set to “16:9” mode.(4) When a 1080i signal is being received, the mode is set to“16:9” mode, and switching is not possible.(5) The aspect mode is memorised separately for differentinput signal formats (NTSC/PAL/SECAM, 525p, RGB andPC). (525p includes 525i and 625i signals.)PLASMA DISPLAYINPUTPCMANUAL- ASPECT - AUTOPICTURE MODEMENU NSTRPICTUREPOS./SIZE12AUTOASPECT -Panasonic AutoFor an elongated image Image is expandedFor a 4:3 imageChanges in accordance with thePanasonic Auto mode setting.(Refer to page 28.)MANUAL- ASPECTJustZoom1 Zoom24:316:9The Wide Plasma Display will allow you to enjoy viewing the picture at its maximum size, including wide screen “cinemaformat” picture.