Panasonic TC-42PD1FA Operating Instructions Manual

Also see for TC-42PD1FA: Service manual

Panasonic TC-42PD1FA Operating Instructions Manual Manual pdf 10 page image

10Basic ControlsPLASMA DISPLAYINPUTPCMANUAL-ASPECT- AUTOPICTURE MODEMENU NSTRPICTUREPOS./SIZEINPUTAV4:3Off timer 30Stand-by (ON/OFF) buttonThe Wide Plasma Display must first be switched on at the walloutlet and at the Power Switch. (See page 9)Push this button to turn the Wide Plasma Display ON, fromSTANDBY mode. Push it again to turn the Wide Plasma DisplayOFF, STANDBY mode.Status ButtonPush the “Status” Button to display thecurrent system status.AV(S-Video)/Component, RGB/PC ModeAspect Mode (See page 18)Off timerThe off timer indicator is displayed onlywhen the off timer has been set.PC Mode SelectionPush the “PC” mode selection button toselect the PC mode.This button is used to switch directly toPC mode.INPUT button(AV(S-Video)/Component, RGB/PCMode Selection)Push the “INPUT” Button to selectAV(S-Video)/Component, RGB/PC inputsignal modes sequentially.Sound mute On/OffVolume AdjustmentPush the Volume Up “+” or Down “–”Button to increase or decrease thesound volume level.ASPECT-AUTO button(see page 18)N button(see page 21,24,25,26)Surround button(see page 22)PICTURE POS./SIZE button(see page 20)STORE buttonCursor buttons to make selectionsand adjustments30 60 900Off Timer ButtonThe Wide Plasma Display may bepreset to switch to stand-by after a fixedperiod.The setting changes to 30 minutes, 60minutes, 90 minutes and 0 minutes (offtimer cancelled) each time the button ispressed.When three minutes remain, “Off timer3” will flash.The off timer is cancelled if the mainssupply fails.ASPECT-MANUAL button(see page 18)PICTURE MODE button(see page 23)MENU buttonVolume AdjustmentPush the Volume Up “+” or Down “–”Button to increase or decrease thevolume level.INPUT button(AV(S-Video)/Component, RGB/PC ModeSelection)Push the “INPUT” Button to select AV(S-Video)/Component, RGB/PC input signal modessequentially.Main PowerOn/Off SwitchPower Indicator