Panasonic SC-ALL9 Operating Instructions Manual

Also see for SC-ALL6: Quick setup guide

Contents

Panasonic SC-ALL9 Operating Instructions Manual Manual pdf 15 page image

SQT1211 15Bluetooth ® operationsBy using the Bluetooth ® connection, you canlisten to the sound of the Bluetooth ® audiodevice wirelessly.≥ Refer to the operating instructions of theBluetooth ® device for further instruction onhow to connect a Bluetooth ® device.Preparation≥ Turn on the Bluetooth ® feature of the deviceand place the device near this unit.∫ Bluetooth ® pairing1 Touch [ ].≥ If the Bluetooth® indicator (blue) blinks fast, go tostep 3.2 To enter pairing mode, touch andhold [ ] for at least 2 seconds.≥ The Bluetooth® indicator (blue) blinks faster.3 Select “SC-ALL9” or “SC-ALL6”from the Bluetooth ® device’s menu.≥ The MAC address “” (“” stands for acharacter that is unique to each set.) may bedisplayed before “SC-ALL9” or “SC-ALL6” isdisplayed.≥ The Bluetooth® indicator (blue) lights up and thedevice is connected to this unit.∫ Connecting a paired Bluetooth®device1 Touch [ ].≥ The Bluetooth® indicator (blue) blinks slowly.≥ If the Bluetooth® indicator (blue) lights, a Bluetooth®device is already connected with this unit.Disconnect it. (l right)2 Select “SC-ALL9” or “SC-ALL6”from the Bluetooth ® device’s menu.3 Start playback on the Bluetooth ®device.∫ Disconnecting a Bluetooth® deviceTouch and hold [ ] for at least 2 seconds.≥ The Bluetooth® indicator (blue) blinks slowly.≥ If prompted for the passkey, input “0000”.≥ You can register up to 8 devices with this unit. If a 9thdevice is paired, the device that has not been used forthe longest time will be replaced.≥ When [ ] is selected as the source, this unit willautomatically try and connect to the last connectedBluetooth® device. If the connection attempt fails, try toestablish a connection again.≥ When the unit is selected as the speakers powered byAllPlay, the audio source will change to the network.≥ Bluetooth® cannot be selected as the audio source whenthe unit is waiting for the WPS PUSH or WPS PIN codeconnection.≥ This unit can only be connected to one device at a time.≥ When enjoying video contents with this function, thevideo and audio output may not be synchronised.This function allows you to connect a pairedBluetooth ® device when this unit is in standbymode.≥ This unit will be turned on automatically whenyou connect a paired Bluetooth® device.– If this function is set to “On”, the standby powerconsumption will increase.Touch and hold [ ] and [1] for at least4 seconds.The mode indicator blinks once.Bluetooth® Stand-by is “On”.The mode indicator blinks twice.Bluetooth® Stand-by is “Off”.≥ You can not set this function during the network indicatorblinking in blue and red.≥ The factory default is “Off”.Connecting via Bluetooth®menuBluetooth® standby