Panasonic SC-ALL9 Operating Instructions Manual

Also see for SC-ALL6: Quick setup guide

Contents

Panasonic SC-ALL9 Operating Instructions Manual Manual pdf 16 page image

16 SQT1211You can change the transmission mode toprioritise transmission quality or sound quality.Preparation≥ Touch [ ].≥ If a Bluetooth ® device is already connected,disconnect it.Touch and hold [ ] and [2] for at least4 seconds.The mode indicator blinks once.Mode1 (Emphasis on connectivity)The mode indicator blinks twice.Mode2 (Emphasis on sound quality)≥ You can not set this function during the network indicatorblinking in blue and red.≥ Select “Mode1” if the sound is interrupted.≥ The factory default is “Mode2”.If the sound input level from the Bluetooth ®device is too low, change the input level setting.Preparation≥ Make sure that a Bluetooth ® device is alreadyconnected with this unit. (l 15)Touch and hold [ ] and [VOL –] for atleast 4 seconds.≥ The mode indicator (amber) blinks to show theBluetooth ® input level.≥ You can not set this function during the network indicatorblinking in blue and red.≥ Select “Low” if the sound is distorted.≥ The factory default is “Low”.AUX inputYou can also listen to music from an externalmusic player through this unit.Preparation≥ Connect an external device. (l 6)1 Touch [AUX].≥ The AUX indicator lights up.2 Start playback on the connecteddevice.∫ To select the sound input level of theexternal deviceWhile in AUX mode, touch and hold [AUX]for at least 4 seconds.The mode indicator blinks once.Normal levelThe mode indicator blinks twice.High level≥ The factory default is “Normal level”.≥ You can not set this function during the network indicatorblinking in blue and red.≥ To improve sound distortion when “High level” isselected, select “Normal level”.≥ Turn the volume of the external device down to reducethe input signal. High level of input signal will distort thesound.≥ For details, refer to the operating instructions of thedevice.≥ When the unit is selected as the speakers powered byAllPlay, the audio source will change to the network.≥ AUX cannot be selected as the audio source when theunit is waiting for the WPS PUSH or WPS PIN codeconnection.Bluetooth® transmissionmodeBluetooth® input levelNumber of blinks Bluetooth ® inputlevel123LowHigh