Panasonic SC-ALL9 Operating Instructions Manual

Also see for SC-ALL6: Quick setup guide

Contents

Panasonic SC-ALL9 Operating Instructions Manual Manual pdf 19 page image

SQT1211 19OthersAs a factory default, there will be a beep soundwhen you touch the switch on the unit.∫ To cancel this functionTouch and hold [1] and [2] for at least4 seconds.≥ The mode indicator (amber) blinks twice.≥ To turn the function on, perform the same operation asthe above.(The mode indicator blinks once.)To check the Wi-Fi signal strength where theunit is located.Touch and hold [NET] and [2] for atleast 4 seconds.≥ The mode indicator (amber) blinks once and then blinksagain to show the Wi-Fi signal strength.≥ If the network indicator is blinking in blue and red, waituntil the blinking stops.≥ If the Wi-Fi signal strength cannot be checked, deselectthe unit from speakers powered by AllPlay, and try again.To check the unit’s IP address and the MACaddress.Preparation≥ Download the app “Panasonic MusicStreaming”. (l 11)1 Start the app “Panasonic MusicStreaming”.2 From “Speaker”, select “ ”.3 Select this unit.≥ This unit will be displayed as “Panasonic ALL9” or”Panasonic ALL6” if the device name is not set.≥ If the network indicator is blinking in blue and red, waituntil the blinking stops.Operation sound settingWi-Fi signal strengthNumber of blinks Wi-Fi signal strength0123WeakStrongIP/MAC address