Panasonic SC-ALL9 Operating Instructions Manual

Also see for SC-ALL6: Quick setup guide

Contents

Panasonic SC-ALL9 Operating Instructions Manual Manual pdf 17 page image

SQT1211 17[SC-ALL6]Rear surroundIf you have a compatible Panasonic HomeTheater Audio System (e.g. SC-ALL70T/SC-ALL30T), you can use two SC-ALL6 units asrear surround speakers to enjoy surroundspeaker sound.≥ Refer to the operating instructions for your compatiblePanasonic Home Theater Audio System.Preparation≥ Turn SC-ALL6 and SC-ALL70T/SC-ALL30Ton.1 Start the pairing mode onSC-ALL70T/SC-ALL30T.2 Touch [REAR MODE] on eachSC-ALL6.≥ The network indicator goes off. (Except when it isblinking alternately in red and blue)≥ The rear surround indicator (green) starts to blinkslowly.3 Touch and hold [REAR MODE] for atleast 4 seconds.≥ The rear surround indicator (green) starts to blink.4 Touch [1] and [REAR MODE] for atleast 4 seconds on one SC-ALL6 asleft surround speaker.≥ The rear surround indicator (green) blinks faster andlights up when pairing is successful.5 Touch [2] and [REAR MODE] for atleast 4 seconds on the otherSC-ALL6 as right surround speaker.≥ The rear surround indicator (blue) blinks faster andlights up when pairing is successful.≥ The pairing mode is cancelled after about 2 minuteselapses. You can also touch [Í/I] to cancel it.≥ When this unit is in rear surround mode, turning thepaired SC-ALL70T/SC-ALL30T on/off will automaticallyturn this unit on/off.≥ The below functions may not be available when this unitis paired as rear surround speaker.– Streaming music by network– Adjusting volume with this unit≥ You cannot adjust the delay time with this unit.≥ If you try to set left and right surround speakers to thesame channel on SC-ALL6, pairing fails.≥ If pairing fails, the rear surround indicator starts to blinkslowly.Repeat the procedure from the beginning if this occurs.PairingSC-ALL70T/SC-ALL30TSC-ALL6SC-ALL6Surround R chSurround L ch